ExamPass EngineeringExamPass Engineering Start free
FE Civil · Knowledge area 9 of 18

Environmental Engineering on the FE Civil exam

Environmental Engineering accounts for 7 of the 110 questions — 6.4% of your exam. It sits in the middle of the paper by weight: too big to skip, not big enough to dominate your plan.

Questions7
Share of exam6.4%
Rank by weight9/18
In our bank24

What Environmental Engineering covers

On the FE Civil exam this area covers water quality parameters, water and wastewater treatment processes, air quality, solid and hazardous waste, and environmental regulation.

What the questions look like: A loading rate, a detention time, a removal efficiency, or a dosage computation.

Worth knowing cold: Most of these reduce to a mass balance across one unit. Write the balance before searching for a process-specific formula.

3 free Environmental Engineering practice problems

These come from our FE Civil bank, written to the same specification as the exam. Try each one before opening the solution.

Problem 1

A detention basin of 2,000 m^3 receives a constant inflow of 0.5 m^3/s of water with a BOD5 of 25 mg/L. Assuming the basin behaves as a well-mixed reactor and BOD decays with first-order rate k = 0.23 /day, what is the approximate BOD leaving the basin after the water resides for the basin's hydraulic detention time?

  1. A24.7 mg/Lcorrect
  2. B18.9 mg/L
  3. C12.5 mg/L
  4. D21.3 mg/L
Show the solution

First find the hydraulic detention time, since it is the exposure time the decay equation needs: t = V/Q = 2,000 m^3 / 0.5 m^3/s = 4,000 s, which converts to 66.7 minutes or 0.0463 days. Then apply the first-order BOD decay equation over that detention time: BOD(t) = BOD0*e^(-k*t) = 25*e^(-0.23*0.0463) = 25*e^(-0.01065) = 25*0.98941 = 24.7 mg/L. Because the detention time is short relative to the decay rate, only a small fraction of the BOD is removed in a single pass through the basin.

Problem 2

A wastewater treatment plant discharges treated effluent into a freshwater river. Immediately downstream of the outfall discharge point, the well-mixed river water possesses the following water quality parameters: - Ultimate first-stage biochemical oxygen demand: L0 = 24.0 mg/L - Initial dissolved oxygen deficit: D0 = 1.50 mg/L - Deoxygenation rate constant (base e): kd = 0.200 day^-1 - Atmospheric reaeration rate constant (base e): kr = 0.500 day^-1 According to the classic Streeter-Phelps oxygen sag model, the critical travel time tc (in days) to reach the minimum dissolved oxygen (maximum oxygen deficit) point is given by: tc = [1 / (kr - kd)] * ln[ (kr / kd) * (1 - D0 * (kr - kd) / (kd * L0)) ] Refer to the accompanying technical diagram [FE-CIV-1745]. What is the critical travel time tc (in days) from the outfall to the point of minimum dissolved oxygen?

  1. A1.85 days
  2. B2.73 dayscorrect
  3. C3.45 days
  4. D4.10 days
Show the solution

Step 1 - Identify the Streeter-Phelps Kinetic Parameters: - Deoxygenation rate constant: $k_d = 0.200\text{ day}^{-1}$ - Reaeration rate constant: $k_r = 0.500\text{ day}^{-1}$ - Initial BOD concentration: $L_0 = 24.0\text{ mg/L}$ - Initial oxygen deficit: $D_0 = 1.50\text{ mg/L}$ Step 2 - Streeter-Phelps Critical Time ($t_c$) Formulation: $$t_c = \frac{1}{k_r - k_d} \ln\left[ \frac{k_r}{k_d} \left( 1 - D_0 \frac{k_r - k_d}{k_d \cdot L_0} \right) \right]$$ Step 3 - Intermediate Algebraic Evaluations: - Difference in rate coefficients: $$k_r - k_d = 0.500 - 0.200 = 0.300\text{ day}^{-1}$$ - Ratio of rate coefficients: $$\frac{k_r}{k_d} = \frac{0.500}{0.200} = 2.500$$ - Initial deficit correction term: $$D_0 \frac{k_r - k_d}{k_d \cdot L_0} = (1.50\text{ mg/L}) \frac{0.300\text{ day}^{-1}}{(0.200\text{ day}^{-1})(24.0\text{ mg/L})} = \frac{0.450}{4.800} = 0.09375$$ - Bracketed factor: $$1 - 0.09375 = 0.90625$$ - Argument of the natural logarithm: $$\text{Arg} = 2.500 \times 0.90625 = 2.265625$$ - Natural logarithm value: $$\ln(2.265625) = 0.817850$$ Step 4 - Calculate Critical Time ($t_c$): $$t_c = \frac{0.817850}{0.300\text{ day}^{-1}} = 2.72617\text{ days} \approx 2.73\text{ days}$$ Step 5 - Distractor Analysis: - Option A ($1.85\text{ days}$) results from omitting the $D_0$ deficit correction term ($t_c = \frac{\ln(2.5)}{0.500} = 1.83\text{ days}$). - Option C ($3.45\text{ days}$) results from using base-10 logarithm in place of natural logarithm ($0.81785 \times 4.22$). - Option D ($4.10\text{ days}$) results from dividing by $k_d$ instead of $(k_r - k_d)$. Therefore, the critical travel time to the oxygen sag point is 2.73 days (Option B).

Problem 3

In the activated sludge process for municipal wastewater treatment, secondary biological treatment utilizes suspended-growth microorganisms to stabilize biodegradable organics. Which of the following operational statements are CORRECT? Select the two that apply.

  1. AOperating at a mean cell residence time (solids retention time, $\theta_c$) greater than 10 to 15 days promotes biological nitrification by providing sufficient retention for slower-growing autotrophic nitrifiers (*Nitrosomonas* and *Nitrobacter*).
  2. BSludge bulking in the secondary clarifier is caused by the complete absence of filamentous bacteria, leading to excessive pin-point floc compaction.
  3. CIncreasing the waste activated sludge (WAS) pumping rate increases the mean cell residence time ($\theta_c$) and decreases the food-to-microorganism ($F/M$) ratio.
  4. DThe primary mechanism of dissolved organic pollutant removal during aerobic biological treatment is the enzymatic synthesis and respiration by heterotrophic bacteria converting soluble organic carbon into new cell mass, $\text{CO}_2$, and $\text{H}_2\text{O}$.
Show the solution

Step 1: Evaluate option A regarding nitrification kinetics: Autotrophic nitrifying bacteria (*Nitrosomonas* which oxidizes ammonia to nitrite, and *Nitrobacter* which oxidizes nitrite to nitrate) have significantly slower maximum specific growth rates ($\mu_m \approx 0.3\text{ to }0.6\text{ day}^{-1}$) compared to heterotrophic organotrophs. To prevent wash-out of nitrifiers from the system, the operational mean cell residence time (solids retention time, $\theta_c$) must exceed the reciprocal of their net specific growth rate (typically $\theta_c \ge 10\text{ to }15\text{ days}$ at $20^\circ\text{C}$). Therefore, statement A is correct. Step 2: Evaluate option B regarding sludge settling and bulking: Sludge bulking in secondary clarifiers is caused by an overgrowth (excess) of filamentous microorganisms (such as *Sphaerotilus natans* or Type 021N) extending beyond the floc boundaries, which creates an open mesh structure that resists compaction and settling. A complete lack of filaments causes pin-point floc, not bulking. Therefore, statement B is incorrect. Step 3: Evaluate option C regarding waste activated sludge (WAS) operation: The mean cell residence time is defined as: $$\theta_c = \dfrac{V X}{Q_w X_w + Q_e X_e}$$ Increasing the waste sludge pumping rate $Q_w$ removes biomass from the system more rapidly, which decreases $\theta_c$. Furthermore, the food-to-microorganism ratio is $F/M = \dfrac{Q S_0}{V X}$. Removing more biomass decreases aeration tank biomass $X$, which increases the $F/M$ ratio. Therefore, statement C is incorrect. Step 4: Evaluate option D regarding biological assimilation and degradation: Aerobic secondary treatment relies on mixed consortia of suspended heterotrophic bacteria that metabolize dissolved biodegradable organic matter (measured as soluble $\text{BOD}_5$) through catabolic respiration (yielding $\text{CO}_2$ and $\text{H}_2\text{O}$) and anabolic synthesis (yielding new biological cell mass/sludge). Therefore, statement D is correct. Distractor Analysis: - Option B reverses the etiology of sludge bulking, attributing it to an absence rather than an excess of filamentous organisms. - Option C contradicts the fundamental definition of solids retention time: wasting more sludge reduces reactor solids inventory and decreases residence time.

Find out where you actually stand

A free 20-question diagnostic across every FE Civil knowledge area, scored in the real exam interface. You get a projected score and the areas costing you the most — so you know whether Environmental Engineering is where your time should go at all.

Start the free Civil diagnostic

Retaking the FE Civil exam?

Copy the scores from your NCEES diagnostic report and see whether Environmental Engineering is where your next attempt gains the most points, or whether another area deserves the time first.

Analyze my diagnostic report

Other FE Civil knowledge areas