ExamPass EngineeringExamPass Engineering Start free
FE Environmental · Knowledge area 4 of 15

Groundwater, Soils, and Sediments on the FE Environmental exam

Groundwater, Soils, and Sediments accounts for 9 of the 110 questions — 8.2% of your exam. It sits in the middle of the paper by weight: too big to skip, not big enough to dominate your plan.

Questions9
Share of exam8.2%
Rank by weight4/15
In our bank30

What Groundwater, Soils, and Sediments covers

On the FE Environmental exam this area covers subsurface characterisation, Darcy’s law, hydraulic conductivity, aquifer properties, well hydraulics, contaminant transport, and soil and sediment remediation.

What the questions look like: A seepage velocity or discharge from Darcy’s law, a drawdown, or a travel time.

Worth knowing cold: Distinguish Darcy velocity from seepage velocity. The factor of porosity between them is a classic trap.

3 free Groundwater, Soils, and Sediments practice problems

These come from our FE Environmental bank, written to the same specification as the exam. Try each one before opening the solution.

Problem 1

A shallow sandy aquifer has a hydraulic conductivity of $K = 1.50 \times 10^{-4}\text{ m/s}$ and an effective porosity of $n_e = 0.25$. Two monitoring piezometers located along the regional flow line $120\text{ m}$ apart measure a head difference of $3.60\text{ m}$. The aquifer soil has a bulk density of $\rho_b = 1.60\text{ g/cm}^3$. A dissolved organic pollutant with a linear distribution sorption coefficient $K_d = 0.40\text{ cm}^3/\text{g}$ enters the groundwater. How many days will it take for the center of mass of the retarded contaminant plume to travel $300\text{ m}$ down-gradient?

  1. A193 days, ignoring sorption and retardation (unretarded pore velocity)
  2. B772 days, using Darcy specific discharge without effective porosity
  3. C484 days, omitting effective porosity from the retardation factor denominator
  4. D687 dayscorrect
Show the solution

Contaminant transport in porous media involves three distinct velocities: Darcy flux ($v$), average linear seepage/pore velocity ($v_s$), and retarded contaminant velocity ($v_c$). Step 1: Hydraulic gradient $i = \dfrac{\Delta h}{L} = \dfrac{3.60\text{ m}}{120\text{ m}} = 0.030$. Step 2: Darcy specific discharge $v = K \cdot i = (1.50 \times 10^{-4}\text{ m/s}) \times 0.030 = 4.50 \times 10^{-6}\text{ m/s}$. Step 3: Groundwater seepage velocity through pore spaces: $v_s = \dfrac{v}{n_e} = \dfrac{4.50 \times 10^{-6}\text{ m/s}}{0.25} = 1.80 \times 10^{-5}\text{ m/s}$. Step 4: Retardation factor due to linear equilibrium adsorption: $R = 1 + \dfrac{\rho_b}{n_e} K_d = 1 + \left(\dfrac{1.60\text{ g/cm}^3}{0.25}\right)(0.40\text{ cm}^3/\text{g}) = 1 + 6.4 \times 0.40 = 1 + 2.56 = 3.56$. Step 5: Plume centroid velocity: $v_c = \dfrac{v_s}{R} = \dfrac{1.80 \times 10^{-5}\text{ m/s}}{3.56} = 5.056 \times 10^{-6}\text{ m/s}$. Step 6: Travel time for $300\text{ m}$: $t = \dfrac{300\text{ m}}{5.056 \times 10^{-6}\text{ m/s}} = 59{,}333{,}333\text{ s}$. Converting to days: $t = \dfrac{59{,}333{,}333}{86{,}400\text{ s/day}} = 686.7\text{ days} \approx 687\text{ days}$. A non-sorbing tracer ($R = 1$) would arrive in only 193 days.

Problem 2

A soil boring for a landfill foundation penetrates a clay formation of total depth H = 8.0 m with solid specific gravity Gs = 2.70 and void ratio e = 0.650 throughout. The groundwater table is located at depth z = 3.0 m below ground surface. In the upper unsaturated zone (0 to 3.0 m), the soil has a gravimetric moisture content of w = 16.0% (0.160). Below the water table (3.0 m to 8.0 m), the clay is completely saturated (S = 1.00). Assuming water unit weight γw = 9.81 kN/m³, calculate the degree of saturation S of the upper layer and determine the effective vertical stress σ′v at depth z = 8.0 m.

  1. AS = 43.2%; σ′v = 75.8 kPa
  2. BS = 58.0%; σ′v = 124.6 kPa
  3. CS = 85.0%; σ′v = 142.1 kPa
  4. DS = 66.5%; σ′v = 106.4 kPacorrect
Show the solution

1. DEGREE OF SATURATION IN UPPER LAYER (0 to 3.0 m): Using fundamental soil phase relationships: $$S e = w G_s \implies S = \frac{w G_s}{e} = \frac{0.160 \times 2.70}{0.650} = \frac{0.432}{0.650} = 0.6646 = 66.5\%$$ 2. TOTAL UNIT WEIGHTS: For the upper partially saturated layer: $$\gamma_1 = \frac{G_s + S e}{1 + e} \gamma_w = \frac{2.70 + 0.432}{1 + 0.650} \times 9.81 = \frac{3.132}{1.650} \times 9.81 = 18.620\text{ kN/m}^3$$ For the lower saturated clay layer ($S = 1.0$): $$\gamma_{\text{sat}} = \frac{G_s + e}{1 + e} \gamma_w = \frac{2.70 + 0.650}{1.650} \times 9.81 = \frac{3.350}{1.650} \times 9.81 = 19.916\text{ kN/m}^3$$ Submerged buoyant unit weight: $$\gamma' = \gamma_{\text{sat}} - \gamma_w = 19.916 - 9.81 = 10.106\text{ kN/m}^3$$ 3. TOTAL AND EFFECTIVE VERTICAL STRESS AT z = 8.0 m: Total overburden stress: $$\sigma_v = (3.0\text{ m} \times 18.620\text{ kN/m}^3) + (5.0\text{ m} \times 19.916\text{ kN/m}^3) = 55.860 + 99.580 = 155.44\text{ kPa}$$ Pore water pressure: $$u = (8.0\text{ m} - 3.0\text{ m}) \times 9.81\text{ kN/m}^3 = 5.0 \times 9.81 = 49.05\text{ kPa}$$ Effective vertical stress: $$\sigma'_v = \sigma_v - u = 155.44 - 49.05 = 106.39\text{ kPa} \approx 106.4\text{ kPa}$$ (Or directly: $\sigma'_v = 3.0 \times 18.620 + 5.0 \times \gamma' = 55.860 + 50.530 = 106.39\text{ kPa}$). DISTRACTOR RATIONALE: - Option A (43.2%, 75.8 kPa) assumes $S = w \cdot G_s$ without dividing by void ratio $e$. - Option B (58.0%, 124.6 kPa) fails to subtract the full hydrostatic head. - Option C (85.0%, 142.1 kPa) uses total stress without pore water subtraction.

Problem 3

A fully penetrating groundwater recovery well pumps at a steady discharge rate of Q = 1,800 m³/day from a confined, homogeneous, isotropic horizontal sand aquifer with uniform thickness b = 18.0 m. Two observation piezometers located at radial distances r₁ = 25.0 m and r₂ = 80.0 m from the centerline of the pumping well record steady-state equilibrium drawdowns of s₁ = 3.20 m and s₂ = 1.45 m, respectively, as shown in the hydrogeologic cross-section. Determine the transmissivity T (in m²/day) and the hydraulic conductivity K (in m/day) of the confined aquifer.

  1. ATransmissivity is 190.4 m2/day and hydraulic conductivity is 10.58 m/daycorrect
  2. BTransmissivity is 245.8 m2/day and hydraulic conductivity is 13.66 m/day
  3. CTransmissivity is 162.1 m2/day and hydraulic conductivity is 9.01 m/day
  4. DTransmissivity is 218.7 m2/day and hydraulic conductivity is 12.15 m/day
Show the solution

**Step 1: Apply the Thiem equilibrium equation for steady radial flow in a confined aquifer** The governing relation between steady discharge and drawdown is: $$T = \frac{Q \ln(r_2 / r_1)}{2 \pi (s_1 - s_2)}$$ Where: - $Q = 1{,}800\text{ m}^3/\text{day}$ - $r_2 / r_1 = 80.0 / 25.0 = 3.20$ - $\ln(3.20) = 1.16315$ - Head difference: $s_1 - s_2 = 3.20\text{ m} - 1.45\text{ m} = 1.75\text{ m}$ **Step 2: Calculate aquifer transmissivity ($T$)** $$T = \frac{1{,}800 \times 1.16315}{2 \pi \times 1.75} = \frac{2{,}093.67}{10.99557} = 190.41\text{ m}^2/\text{day} \approx 190.4\text{ m}^2/\text{day}$$ **Step 3: Calculate hydraulic conductivity ($K$)** Given aquifer thickness $b = 18.0\text{ m}$: $$K = \frac{T}{b} = \frac{190.41\text{ m}^2/\text{day}}{18.0\text{ m}} = 10.578\text{ m/day} \approx 10.58\text{ m/day}$$ In standard metric velocity units: $K = \frac{10.58}{86{,}400} = 1.224 \times 10^{-4}\text{ m/s}$. **Distractor Rationale:** - Option B uses common logarithm $\log_{10}(3.20) = 0.505$ instead of natural logarithm. - Option C omits the factor of 2 in $2\pi$. - Option D mistakenly applies the Dupuit unconfined quadratic drawdown relation.

Find out where you actually stand

A free 20-question diagnostic across every FE Environmental knowledge area, scored in the real exam interface. You get a projected score and the areas costing you the most — so you know whether Groundwater, Soils, and Sediments is where your time should go at all.

Start the free Environmental diagnostic

Retaking the FE Environmental exam?

Copy the scores from your NCEES diagnostic report and see whether Groundwater, Soils, and Sediments is where your next attempt gains the most points, or whether another area deserves the time first.

Analyze my diagnostic report

Other FE Environmental knowledge areas