ExamPass EngineeringExamPass Engineering Start free
FE Environmental · Knowledge area 9 of 15

Mathematics on the FE Environmental exam

Mathematics accounts for 6 of the 110 questions — 5.5% of your exam. It sits in the middle of the paper by weight: too big to skip, not big enough to dominate your plan.

Questions6
Share of exam5.5%
Rank by weight9/15
In our bank20

What Mathematics covers

On the FE Environmental exam this area covers algebra and trigonometry, analytic geometry, vectors, matrix and determinant operations, differential and integral calculus, differential equations, and numerical methods.

What the questions look like: Short, self-contained computations: a determinant, a derivative evaluated at a point, the area under a curve, a dot or cross product, or the root of an equation by Newton’s method.

Worth knowing cold: These are the cheapest points on the exam and the fastest to lose. Practise them until they take under a minute each, because the time you save here is time you spend on the long discipline questions.

3 free Mathematics practice problems

These come from our FE Environmental bank, written to the same specification as the exam. Try each one before opening the solution.

Problem 1

A completely mixed reactor (CSTR) of volume 200 m³ treats a flow of 25 m³/hr. At time zero, the inflow concentration steps up to 40 mg/L (previously the reactor was at zero concentration) and stays constant afterward. Using the mass-balance solution for a step input into a CSTR, $C(t) = C_{in}\left(1 - e^{-t/\tau}\right)$ with $\tau = V/Q$, what is the reactor's outlet concentration 12 hours after the step change?

  1. A31.08 mg/Lcorrect
  2. B40.00 mg/L, assuming the reactor reaches the new inflow concentration instantly
  3. C15.00 mg/L, using $t/\tau$ inverted in the exponent
  4. D8.92 mg/L, which is $C_{in}$ times the exponential decay term alone, omitting the 1 minus the exponential
Show the solution

A completely mixed reactor cannot jump instantly to a new inflow concentration, because the outflow concentration equals the concentration throughout the tank, and that tank concentration can only change as fast as the actual flow of material replaces what's already inside — this first-order lag is captured by the hydraulic residence time $\tau$. Residence time: $\tau = \dfrac{V}{Q} = \dfrac{200}{25} = 8$ hours. At $t = 12$ hours, the ratio $t/\tau = 1.5$. Concentration: $C(12) = 40\left(1 - e^{-1.5}\right) = 40(1 - 0.2231) = 40(0.7769) = 31.08$ mg/L. Notice that after 12 hours — 1.5 times the residence time — the reactor has reached about 78% of the way to the new steady-state concentration, and it would take several more residence times to get meaningfully closer to the full 40 mg/L; this slow asymptotic approach is a defining, often underappreciated characteristic of completely mixed systems, in contrast to a plug-flow reactor, which would show the full step change arrive abruptly after exactly one residence time.

Problem 2

In an environmental biotechnology laboratory, microbial substrate utilization kinetics are modeled using the Monod / Michaelis-Menten formulation: U = (U_max · S) / (Ks + S), where U is the specific substrate utilization rate in day⁻¹ and S is the substrate concentration in mg/L. To determine the biokinetic parameters, researchers apply the Lineweaver-Burk linear transformation: 1/U = (Ks / U_max)·(1/S) + (1 / U_max). A linear least-squares regression of experimental data with y = 1/U (in days) and x = 1/S (in L/mg) yields the regression equation y = 18.50 x + 0.250. Calculate the half-velocity constant (Ks) of this microbial consortium in mg/L.

Show the solution

1. LINEWEAVER-BURK LINEARIZATION: Starting with the Monod relation: $$U = \frac{U_{\max} S}{K_s + S}$$ Taking the reciprocal of both sides: $$\frac{1}{U} = \frac{K_s + S}{U_{\max} S} = \frac{K_s}{U_{\max}} \left(\frac{1}{S}\right) + \frac{1}{U_{\max}}$$ Comparing with the standard slope-intercept form $y = m x + b$: $$\text{Slope } m = \frac{K_s}{U_{\max}} = 18.50\text{ day}\cdot\text{mg/L}$$ $$y\text{-intercept } b = \frac{1}{U_{\max}} = 0.250\text{ day}$$ 2. MAXIMUM UTILIZATION RATE (U_max): $$U_{\max} = \frac{1}{b} = \frac{1}{0.250\text{ day}} = 4.00\text{ day}^{-1}$$ 3. HALF-VELOCITY CONSTANT (Ks): $$K_s = m \times U_{\max} = (18.50\text{ day}\cdot\text{mg/L}) \times (4.00\text{ day}^{-1}) = 74.00\text{ mg/L}$$ Alternatively: $$K_s = \frac{\text{Slope}}{y\text{-intercept}} = \frac{18.50}{0.250} = 74.0\text{ mg/L}$$ Acceptable range: [72.0, 76.0] mg/L.

Problem 3

In groundwater solute transport modeling, a 2D continuous contaminant concentration plume C(x,y) (in mg/L) originating from an industrial surface spill is governed by: $$C(x,y) = 150 \exp\left( -0.02 x - 0.05 y^2 \right)$$ where x is longitudinal down-gradient distance in meters and y is transverse offset distance in meters. Evaluate the directional derivative of the concentration field Du⃗ C at monitoring well location P(x = 50.0 m, y = 2.0 m) in the direction of the vector v⃗ = 3 î + 4 ĵ pointing toward a municipal water supply wellfield. Enter your calculated directional derivative with its negative sign in mg/(L·m).

Show the solution

1. GRADIENT VECTOR ∇C(x,y): Given $C(x,y) = 150 \exp(u)$ where $u = -0.02 x - 0.05 y^2$: - Partial derivative with respect to $x$: $$\frac{\partial C}{\partial x} = 150 \exp(u) \cdot (-0.02) = -0.02 \cdot C(x,y)$$ - Partial derivative with respect to $y$: $$\frac{\partial C}{\partial y} = 150 \exp(u) \cdot (-0.10 y) = -0.10 y \cdot C(x,y)$$ 2. EVALUATION AT POINT P(50.0, 2.0): Exponent $u$: $$u = -0.02(50.0) - 0.05(2.0)^2 = -1.00 - 0.20 = -1.20$$ Concentration at P: $$C(50.0, 2.0) = 150 \exp(-1.20) = 150 \times 0.3011942 = 45.1791\text{ mg/L}$$ Gradient components: $$\frac{\partial C}{\partial x} = -0.02 \times 45.1791 = -0.90358\text{ mg/(L}\cdot\text{m)}$$ $$\frac{\partial C}{\partial y} = -0.10(2.0) \times 45.1791 = -0.20 \times 45.1791 = -9.03582\text{ mg/(L}\cdot\text{m)}$$ 3. UNIT DIRECTION VECTOR û: Direction vector: $\vec{v} = 3 \hat{i} + 4 \hat{j}$ Magnitude: $|\vec{v}| = \sqrt{3^2 + 4^2} = 5.0$ $$\hat{u} = \frac{\vec{v}}{|\vec{v}|} = \frac{3}{5}\hat{i} + \frac{4}{5}\hat{j} = 0.60\hat{i} + 0.80\hat{j}$$ 4. DIRECTIONAL DERIVATIVE: $$D_{\hat{u}} C = \nabla C \cdot \hat{u} = (-0.90358)(0.60) + (-9.03582)(0.80)$$ $$D_{\hat{u}} C = -0.54215 - 7.22866 = -7.7708\text{ mg/(L}\cdot\text{m)} \approx -7.77\text{ mg/(L}\cdot\text{m)}$$

Find out where you actually stand

A free 20-question diagnostic across every FE Environmental knowledge area, scored in the real exam interface. You get a projected score and the areas costing you the most — so you know whether Mathematics is where your time should go at all.

Start the free Environmental diagnostic

Retaking the FE Environmental exam?

Copy the scores from your NCEES diagnostic report and see whether Mathematics is where your next attempt gains the most points, or whether another area deserves the time first.

Analyze my diagnostic report

Other FE Environmental knowledge areas

Mathematics on other FE exams

The same knowledge area is weighted differently on each exam, and the questions differ with it.